serviceWhether it’s Spring, Summer, Fall or Winter, having a properly tuned bike is important to safe enjoyment of any type of cycling. Don’t have time to go through the full bike inspection of your bike, checkout the price list for the basics. If you see a problem let us checkout your bike. A typical basic tune-up costs between $30 - $50. Check the complete list of Prescott Valley Bike Works service and repair fees.

Lube
Apply lubrication to the chain. It should be applied so there is an even coat on the inside and outside of each link and between the pins and rollers. Leave it one for a few minutes, then wipe off the excess lube with a rag. A few drops should be added to the cables at the nipple end. Gore-Tex and other Teflon cables should never be lubricated. All the pivot points on the front and rear derailleur should be oiled. Apply a few drops to the brake lever pivots and to the exposed brake cable.

Brake System
Check the brake pads. Unfasten the brake cable and look at the brake pads closely. The pads should be wearing evenly. If you have a ridge in the pads then your brakes may need to be adjusted. If the pads are worn or not smooth then get some new pads. Old brake pads tend to harden and If the pads are ok then reconnect the straddle cable and squeeze the brakes. Do the pads strike the rim at the same time? You can adjust the brake arm tension screw that is usually on one of the brake arms so the brakes are even.

Cleaning
It is important to start with a clean bike. Keeping your bike clean will extend the life of your components. As you clean the bike take the time to inspect everything. Look for cracks or other signs of wear that could cause future breakdowns or part failures. Clean the chain, chainrings, cassette, derailleurs, etc. with a biodegradable cleaner. Simple green works great for this. Use an old tooth brush and clean everything. Use as little water as possible. Clean the pedals, the brakes, tires, rims, and the frame. Remove the seatpost from the frame and wipe off any dirt. Wipe the inside of the frame where the seatpost slides into. Apply a very small amount of good grease to the post and reinstall.

Wheels
Clean the rims with a cloth and rubbing alcohol, beer won't work! Check the rim for pits or grooves in the sidewall of the rim. Spin the wheels. Do they go around straight or do they wobble? You can make minor adjustments to the wheel with a spoke wrench. For major tweaking take it to a shop or use a truing stand and get it back in true.

Drivetrain
Elevate the rear wheel and spin the pedals. This is where a stand comes in handy. Shift through all the rear gears. Shifting from gear to gear should be smooth. If it skips try adjusting your rear derailleur. If this fails to correct the problem your chain, cogset, and chainrings may be worn. The chain is the first to go. Chains last from 6 months to a year. A good chain only costs $15-40 and is well worth the investment. Examine your chain closely for side slop and stretch which are signs that your chain is wearing out. If your chain is worn it can prematurely wear on your cogs and rings. In the front try shifting the derailleur. Adjust your front derailleur if needed. Check the front chainrings for excessive wear or missing teeth. Small chainrings wear out much faster your larger ones. If all is well your bike will now shift perfect. Apply some fresh lube of your preference.

Tires
If the brake pads were out of alignment they may have damaged the tires. Check tires for splits, cracks, or tears in the sidewall. Check the tread of the tire for worn knobs, uneven tread wear, or excessive wear. Replace the tires if needed. There is nothing worse than having a tire blow out because it needed to be replaced.

Cables
If you ride all year round you should replace your brake and/or derailleur housing once per year. If you keep your bike clean you can use the same housing for many years. For all other then once every 2-5 years is fine. Dirty or rusty cables will diminish shifting performance. You can purchase bulk housing and install it yourself if you have some quality cable cutters. The cable ferules can be reused. Install the new housing and adjust the brakes and derailleurs. Fresh cables make shifting and braking smooth.

Services

Wheel Repairs
Tire/tube install off bike…………………..….. $5.00
Tire/tube install on bike (Front)…………..…$10.00
Tire/tube install on bike (Rear)…….……..…$12.00
Wheel truing…………………………………..$12.00 to 17.00
Adjust Hub…….………………………………..$6.00 to $8.00
Overhaul front hub………………………….. $18.00 to $30.00

Brake Repairs
Brake Adjustment…………………………………$8.00 to $10.00
Brake cable install………………………………$10.00 to 12.00
Rim brake install (each)………………………….$7.00 to $10.00
Disk brake install (each)……………………….$20.00 to $40.00
Rotor install………………..……………………..$5.00
Brake lever install……………………………….$18.00 to $25.00

Drivetrain Repairs
Tune & clean drivetrain…………………………$65.00
Chain install……………………………………….$8.00
Cassette/freewheel install……………..………..$5.00 to 8.00
Adjust bottom bracket…………..……………..$10.00
Bottom bracket install …………………………..$20.00 to $25.00
Overhaul bottom bracket………….…………..$20.00 to 25.00
Crankset install …………………………………$25.00 to $30.00
Chainring install (each)………………….……..$10.00

Shifter & Derailleur Repairs
Rear derailleur adjustment …………………….$10.00
Front derailleur adjustment……………………..$10.00
Rear derailleur install………..…………….……..$15.00 to $20.00
Front derailleur install……………………………$15.00 to $20.00
Shifter cable install (each)………..…………….$10.00 to $14.00
Mountain shifter install (pair)……………………$25.00 to $40.00
Road shifter/levers install(pair)…………….…..$30.00 to $45.00

Fork, Headset & Bar Repairs
Adjust Headset…………………………………..$5.00
Overhaul headset……..……………………….$25.00
Headset install………………………………….$20.00 to $25.00
Fork install………..…………………………….$20.00 to $35.00
Mountain bar install…………..………………..$14.00 to $20.00
Road bar install………….……………………..$25.00 to $35.00
Grip install……..…………………………………$5.00
Wrap handlebars.………………………………$20.00

Stem install………………………………………$10.00 to $20.00

Computer install……..………………………….$10.00 to $20.00

Prices may change without notice.